Re: 585 questions



- ----- Original Message ----- 
From: "Hambone Hamilton" <harpmanx@xxxxxxxxxxx>
To: <rgermon@xxxxxxxxxxxx>; <harp-l@xxxxxxxxxx>
Sent: Thursday, October 09, 2003 1:28 PM
Subject: Re: 585 questions


>
> Roy,
> I can't help about the impedance, but you can get a cord from
> www.harmonicamasterclass.com
>
> Hambone
>
>
> >From: Roy G <rgermon@xxxxxxxxxxxx>
> >Reply-To: Roy G <rgermon@xxxxxxxxxxxx>
> >To: harp-l@xxxxxxxxxx
> >Subject: 585 questions
> >Date: Thu, 09 Oct 2003 10:35:52 -0400
> >
> >
> >Hey folks,
> >
> >A few months back I bought an untested 585 off of Ebay.  Since then it
has
> >sat in my drawer.  It's time to pull it out and test it.  The thing has a
4
> >pin connector.  What I want to do is get a cord for it, and make sure
it's
> >set up for high impedence.  I haven't seen a 4 pin cord in any of the
> >stores I've been in...only 3 pin.  Any advice on what cord I need, where
I
> >can get one, and how I go about  setting it up for high impedence?

Hi,
A Shure 585 has a screw on connector much like the pre-1984 Astatic JT30's
and the EV 605's, and what you're describing is a Shure 565, not a 585.

Sincerely,
Barbeque Bob Maglinte
Boston, MA





This archive was generated by a fusion of Pipermail 0.09 (Mailman edition) and MHonArc 2.6.8.