Re: [Harp-L] RE: SP20 reedplate screws (nonametribe)



Rick - 

Do you happen to know the metric screw size used for SP20 reedplates? I
know that this would be of interest to more than one person on the
list.

Thanks.

Winslow

--- rick epping <rickepping@xxxxxxxxx> wrote:

> Sorry - forgot to edit the subject...
> R.
> 
> ---------- Forwarded message ----------
> From: rick epping <rickepping@xxxxxxxxx>
> Date: Dec 18, 2006 7:56 PM
> Subject: Re: Harp-L Digest, Vol 40, Issue 62
> To: harp-l@xxxxxxxxxx
> 
> 
> When reedplate screw hole threads strip, I place the reedplate on an
> anvil
> and carefully hammer the screw hole with a flat-faced nailset having
> a
> diameter a little greater than that of the screw hole, or similarly
> use the
> riveting bit on my Farrell reed replacement tool, which has about the
> right
> diameter.  This reduces the diameter of the screw hole enough to grip
> the
> screw again.
> 
> Best regards,
> Rick Epping
> 
> 
>  Message: 4
> Date: Mon, 18 Dec 2006 11:26:59 -0500 (GMT-05:00)
> From: nonametribe <nonametribe@xxxxxxxxxxxxx >
> Subject: [Harp-L] SP20 reedplate screws
> To: harp-l@xxxxxxxxxx
> Message-ID:
>       
>
<31359971.1166459220256.JavaMail.root@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> >
> 
> Content-Type: text/plain; charset=UTF-8
> 
> Any one suggest the correct replacement screw for stripped out
> threads in
> the bottom reedplate on SP20?
> _______________________________________________
> Harp-L is sponsored by SPAH, http://www.spah.org
> Harp-L@xxxxxxxxxx
> http://harp-l.org/mailman/listinfo/harp-l
> 


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 




This archive was generated by a fusion of Pipermail 0.09 (Mailman edition) and MHonArc 2.6.8.