Re: [Harp-L] Re: Big River reedplate edges



Hehe - We like that! The other thing you can do with Big River harps is to nick the reeds to replace dead reeds in your Meisterclasse. I also quite like the cover plates with the vents in them too. I've got a Bb Meisterclasse with Big River Plates and it's an absolute beast!

Cheers

Bill
----- Original Message ----- From: "Mox Gowland" <mox.g@xxxxxxxxx>
To: <harp-l@xxxxxxxxxx>
Sent: Monday, October 05, 2009 3:48 PM
Subject: [Harp-L] Re: Big River reedplate edges



This subject is also being discused on another harp forum The following solution I find quite original.

*****************************************************....... easy solution, cut two strips of fine sandpaper about two inches long by one half inch wide and glue them in the appropriate locations on your upper and lower lips. Now be careful to use water soluble glue. One time I used a petroleum based glue, got dizzy from the fumes and put the sandpaper pads on crooked. Got so high that I forgot to take them off and later wondered why the girl at the Mc Donalds drive thru was laughing so hard.
Reach on****************************************/*






http://www.youtube.com/user/hokumsheik

_______________________________________________
Harp-L is sponsored by SPAH, http://www.spah.org
Harp-L@xxxxxxxxxx
http://harp-l.org/mailman/listinfo/harp-l





This archive was generated by a fusion of Pipermail 0.09 (Mailman edition) and MHonArc 2.6.8.